Reasons and solutions for faults in horizontal sand mills:

Motor overload: It may be caused by too much material inside the equipment or too fast feeding speed. The material load should be appropriately reduced or the feeding speed should be controlled.

Bearing overheating: It may be caused by insufficient lubrication or damage to the bearing, and lubricating oil should be added or the bearing should be replaced in a timely manner.

Gear transmission failure: It may be caused by gear damage or insufficient lubrication, and the gear should be replaced or lubricated in a timely manner.

Wear of the grinding body: After prolonged use, the surface of the grinding body may experience wear, and the grinding body should be replaced in a timely manner.

Blockage of inlet and outlet: It may be caused by material suspension or excessive feeding, and the feeding amount should be appropriately reduced or the inlet and outlet should be cleaned.